Leprecon LP-3000 Series User Manual
Page 53
Presets
Chapter Four
49
LP-3000 Users Manual
Record Mode
Page 1
Record mode is also indicated by flashing yellow LEDs in the row of
numbered preset Select buttons.
4.
Raise the Preset Master fader to the desired level.
5.
Set up the scene, using any combination of X and Y channel faders and
other presets.
6.
When the new scene is correct, press the gray Select button over the preset
playback that you want to program with the new scene.
The Mode display will then verify which preset has just been recorded.
Recorded
Pg 01, Preset 01
7.
To leave the record mode of the LP3000, press the Run button.
8.
Return the key switch to the Lock position after all preset recording has
been completed.
Preset playbacks which are in “page hold”, marked by red LEDs, can also be
recorded; but the new scene will be stored in place of the preset which is currently
active, not the preset location indicated by the Page roller. In other words, if the
Page Roller is on page 5 and preset 1 is brought up, the roller is moved to page 6.
At that point, the LED over preset playback 1 turns red. Pressing the Select button
for Preset 1 records the on-stage scene into preset 1 of page 5, not page 6.
Preset 0 does not change when a new page is selected. Therefore, it can be
recorded at any time.
To Play Back Presets
1.
Put the LP-3000 in Run mode by pressing the Run button to the right of the
key switch.
2.
Set the Page roller to the desired page.
3.
Raise the Preset Master to the desired level.
4.
Raise the Preset Playback fader to the desired level.
To Preview Presets
You can preview any preset entered in the LP-3000 instantly whenever the board is
in Run mode.
1.
Put the LP-3000 in Run mode by pressing the Run button to the right of the
key switch.