Leprecon LP-3000 Series - Manual (Page 93)

Moving Light Cue Programming Chapter Eight 89
LP-3000 Users Manual
To: Do:
Include a group in
a cue. Use the Group edgewheel to select a group from
the Group list. Click the Group Select button. The
LP-3000 displays the names of the individual
instruments from the group in the Instruments in
Cue list.
Remove one
member of a group
from a cue. Follow the procedure for removing individual
instruments from a cue.
Remove a group
from a cue. Follow the procedure for removing individual
instruments from a cue. Repeat for each instrument
in the group.
Delete an
unwanted group. Use the Group edgewheel to select a group from
the Group list. Click Remove Group. This action is
permanent and cannot be undone.
NOTE: To use a group in playback mode, the instruments in the group must be
included in the Instruments in Cue list.
Live Mode versus Blind Mode
Preset 0 controls the output of the Programmer screen. With Preset 0 at 0%,
changes are not visible on stage as a cue is built. This is referred to as a “blind”
cue. With Preset 0 at any position greater than 0%, the effect of changes in label
selections is visible on stage as the cue is built. This is referred to as a “live” cue.
To switch between live and blind mode, adjust Preset 0 (located at the far left of the
preset playbacks) to the correct level for “live” or “blind” programming.
To: Do:
Build a “blind” cue. Adjust Preset 0 to 0%.
Build a “live” cue. Adjust Preset 0 above 0%.
The LP-3000 displays the Programming Mode (live or blind) at the top of the
Programmer screen and many others.
Setting Cue Properties
After you have selected the instruments and groups for the cue, you are ready to
set the properties for each fixture in the cue.