Leprecon LP-3000 Series - Manual (Page 97)

Moving Light Cue Programming Chapter Eight 93
LP-3000 Users Manual
Saving the Cue to a Playback
Moving Light cues can be directly assigned to faders for playback. The process is
similar to other areas of the LP-3000; 20 pages of 18 playbacks are used to
process Moving Light cues as well as conventional looks.
Each playback fader can store a single Moving Light cue or a sequence of cues—
called a cuelist. Once stored to a fader, the cues in the cuelist can be played back
one at a time or converted to a Moving Light chase or stack.
To Save the Cue to a Playback
With the Programmer screen displaying the cue you just created:
1. Move the key switch to the Unlock position.
2. Press the Record button, located to the right of the key switch.
3. Use the Page edgewheel to select the desired page.
The Page edgewheel is located to the left of the Preset Title displays.
4. Create a look for one instrument or group.
5. Press the Solo button of the desired playback to save the look as the first
step of the Moving Light sequence or “cue list”.
CAUTION: Pressing the Solo button erases all steps of any Moving Light
cuelist assigned to the Preset Playback for that page.
The LP-3000 saves the cue to the playback and automatically assigns it a
name that reflects its page, playback and step number. For example, a cue
named:
pg01_pb01_s01
has been recorded to Page 1, Playback 1, Step 1.
6. If desired, deselect the instrument or group, select a different instrument or
group, create a look and press Save.
7. Set additional steps.
Continue to select instruments and set properties using either label
programming or attribute programming.
Press the Add button of the playback to save each additional step. The LP-
3000 automatically assigns a name to each new cue, such as:
Pg01_pb01_s02
8. Press the Run button, located to the right of the key switch, to stop
recording.