Leprecon LP-3000 Series - Manual (Page 117)

Advanced Moving Light Cue Programming Chapter Ten 113
LP-3000 Users Manual
By default, Hold Time is set to INF. (Infinite) and Fade Time is set to two
seconds. These values may be different if you changed them in the Options
screen. For more information please see Options beginning on page 41.
Times are displayed showing minutes, seconds and tenths of a second
(0:00.0 or 2:30.5).
6. Do one or more of the following:
To: Do:
Set the Hold
Time for all
properties. Click Hold Time. Using the edgewheel for any
property, change the value. Reminder: Hold Time
values cannot be set independently. The Hold Time
value for all properties is always the same.
Set the Start
Delay for a
property. Click Start Delay. Using the edgewheel for the
property, change the value. Reminder: Start Delay
values can be set independently for each property.
Set the Fade
Time for a
property. Click Fade Time. Using the edgewheel for the
property, change the value. Reminder: Fade Time
values can be set independently for each property.
The Fade Time value should be equal to or shorter
than the Hold Time value if you want the cue to fade
in completely.
7. When you are done setting the timing and playback values for the cue, click
Save & Exit to Programmer.
The LP-3000 displays the Programmer screen.