Leprecon LP-3000 Series - Manual (Page 121)

Attribute Programming Chapter Eleven 117
LP-3000 Users Manual
You can also assign attributes to edgewheels by pointing to the first attribute
you want to assign and clicking the left mouse button.
5. Using the edgewheels, select the DMX value for each attribute.
Values range from 0 to 256.
For most attributes, you can select the option No Change. This means that
the cue will not change the previous setting for the property during playback.
To select No Change, set the attribute to its highest value.
6. To aid you in making your selection, press and hold the edgewheel’s
Selector button to activate the Snap To function. Then use the edgewheel
to snap from label to label for the instrument.
This is a method by which you can rapidly move from pre-defined label to
pre-defined label rather than working your way through the full range of
DMX values.
Note that the Snap To function is not available in off-line mode.
7. When you are done, click Save or Save As.
For an alternate way to save cues, please see Saving the Cue to a
Playback beginning on page 93.
8. If you have more than one instrument in the cue:
a. Press the Next button.
b. Repeat steps 5 through 7 above.
c. Click Save.