Leprecon LP-3000 Series User Manual
Page 120
116
Chapter Eleven
Attribute Programming
LP-3000 Users Manual
4.
Using the Attribute Select edgewheel, select the group of attributes that the
remaining edgewheels will control.
With Attribute Select set to 0, the edgewheels control the first three
attributes as shown below.
With Attribute Select set to 1, the edgewheels control the second, third and
fourth attributes as shown below.
The 1st highlighted
selection is assigned to
the left edgewheel.
The 2nd highlighted
selection is assigned to
the middle edgewheel.
The 3
rd
highlighted
selection is assigned to
the right edgewheel.
The 1st highlighted
selection is assigned to
the left edgewheel.
The 2nd highlighted
selection is assigned to
the middle edgewheel.
The 3
rd
highlighted
selection is assigned to
the right edgewheel.