Leprecon LP-3000 Series - Manual (Page 41)

System Tools Chapter Three 37
LP-3000 Users Manual
The Dimmer Patch screen shows the name of the active patch in the display box in
the upper right corner of the screen. The vertical columns contain the board
channel, DMX line assignment and dimmers patched to each line.
Two very important controls are present in this screen—View By and View.
View By gives you the ability to view the patch information either by dimmer circuits
or by board channel.
•
If View By is in the Channels position (default), the list will display in
increasing board channel numbers. Each board channel lists the dimmers
that it controls and the patch level.
•
If View By is in the Dimmers position, the list will be organized by increasing
dimmer number and each dimmer will show only one channel value.
You can set View to Used or Unused.
•
Select Used to re-patch dimmers or channels that are already assigned.
•
Change to Unused to see board channels or dimmers that are currently
free.
At the bottom of the panel, the Scroll edgewheel is used to scroll through the list of
board channels.
To Select a Patch
The Select Patch button is used to select from the 20 patches available in the LP-
3000.
1. From the Main screen, click Setup and then Dimmer Patch.