Leprecon LP-3000 Series - Manual (Page 61)

LP-3000 Users Manual
Chapter Five:
Chases
The chaser section of the LP-3000 is used to build simple endless loops of
scenes—called chases. Chases can consist of up to 25 steps, and up to 360
chases can be saved. Up to eighteen chases can be run at the same time.
All chases are assigned to preset playbacks. This allows a chase to be combined
with a conventional look, or a chase alone can be started by bringing up the
playback.
The LP-3000 provides three distinct methods for programming chases.
•
The simplest method is creating chases with playbacks, which uses the
Bump buttons of the preset playbacks to store the chase.
•
You can also use the Chase Builder screen, which uses the LP-3000
screen controls to assist in building the chase.
•
Finally, you can use the Step Editor if you need to create a chase in off-line
programming mode.
Creating Chases with Playbacks
The fastest method of programming a chase uses the Add and Solo buttons of the
playback to store a chase.
To Create a Chase on a Playback
1. From the Main screen, click Chase.
The LP-3000 displays the Chase Builder screen.