Lenze 8400 - Manual (Page 1006)

16 Parameter reference
16.2 Parameter list | C01240
1006
Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Bit 11 EnableSpeedOverride Control bit for activation of speed override
• "1" ≡ activation of the override speed at the MCK for
acceptance in a running speed profile.
Bit 12 EnableAccOverride Control bit for activation of acceleration override
• "1" ≡ activation of the override acceleration at the
MCK for acceptance in a running speed profile.
Bit 13 EnableSRampOverride Control bit for deactivation of S-shaping for speed
profiles
• "1" ≡ deactivates S-shaping for speed profiles
Bit 14 PosTeachSetPos Control bit for accepting the selected setpoint position in
the selected profile
• "0->1" ≡ accepts the setpoint position at the MCK in
the profile with the profile number defined via the
MCK control word.
Bit 15 PosTeachActPos Control bit for accepting the current actual position in
the selected profile
• "0->1" ≡ accepts the current actual position in the
profile with the profile number defined via the MCK
control word.
Bit 16 PosExecute Control bit for starting a positioning profile
• "0->1" ≡ starts a positioning profile selected via the
control word in the "Positioning" mode.
Bit 17 PosFinishTarget Control bit for completing processing of an interrupted
positioning profile
• "0->1" ≡ processing of a positioning profile which has
already been started and has been interrupted
because of a cancellation condition or a change of the
operating mode is completed in the "Positioning"
mode when the home position is known.
• Note: Completion of profile processing through this
control is based on the target position detected at the
profile start!
Bit 18 PosDisableFollowProfile Control bit for suppression of the sequence profile
• "1" ≡ positioning profiles whose profile numbers are
entered in profile data sets for sequence profiles are
not started after completion of the corresponding
profile.
Bit 19 PosStop Control bit for stopping the positioning profile
• "0->1" ≡ ("Positioning" mode): Interrupts a running
profile through deceleration along the set
deceleration ramp to standstill.
• "0->1" ≡ ("Stop" mode): Starts a new deceleration to
standstill with the parameterised stop ramp.
Bit 20 PosModeBit0 Active positioning mode - control bit 0
Bit 21 PosModeBit1 Active positioning mode - control bit 1
Bit 22 PosModeBit2 Active positioning mode - control bit 2
Bit 23 PosModeBit3 Active positioning mode - control bit 3
Bit 24 ProfileNo_Bit0 Active positioning profile number - control bit 0
Bit 25 ProfileNo_Bit1 Active positioning profile number - control bit 1
Bit 26 ProfileNo_Bit2 Active positioning profile number - control bit 2
Bit 27 ProfileNo_Bit3 Active positioning profile number - control bit 3
Bit 28 ProfileNo_Bit4 Active positioning profile number - control bit 4
Bit 29 ProfileNo_Bit5 Active positioning profile number - control bit 5
Bit 30 ProfileNo_Bit6 Active positioning profile number - control bit 6
Parameter | Name:
C01240 | MCK: Control word
Data type: UNSIGNED_32
Index: 23335
d
= 5B27
h