Lenze 8400 - Manual (Page 573)

Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
573
9 Diagnostics & error management
9.7 Monitoring
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
9.7 Monitoring
The controller is provided with various monitoring functions which protect the drive against
impermissible operating conditions.
• If a monitoring function responds,
• an entry will be made into the Logbook of the controller,
• the response (TroubleQSP, Warning, Fault, etc.) set for this monitoring function will be
triggered,
• the status of the internal device control changes according to the selected response,
controller inhibit is set, and the "DRV- ERR" LED on the front of the controller goes on:
Related topics:
 LED status displays of the device status ( 556)
 Device state machine and device statuses ( 108)
 Device overload monitoring (Ixt) ( 282)
 Motor load monitoring (I2xt) ( 282)
 Motor temperature monitoring (PTC) ( 285)
 Brake resistor monitoring (I2xt) ( 286)
 Motor phase failure monitoring ( 288)
 Mains phase failure monitoring ( 291)
 Maximum current monitoring ( 291)
 Maximum torque monitoring ( 292)
 Encoder open-circuit monitoring ( 293)
Response Entry in the
logbook
Display in
C00168
Pulse inhibit Controller
inhibit
Acknowledge
ment
required
"DRV-ERR" LED
None OFF
Fault     
Trouble    
TroubleQSP   
WarningLocked   
Warning  
Information   OFF
System fault     Mains
switching
is required!