Lenze 8400 - Manual (Page 74)

3 Commissioning
3.8 Commissioning of the "Table positioning" technology application
74
Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
3.8.4.4 Enter one or more profiles
1. Click the Profile entry button (in the "MotionControlKernel" block) in the signal flow to change
to the Overview  Signal flow  Profile entry dialog level:

You can find detailed information on entering profiles in the chapter entitled "Basic drive
functions", subchapter " Profile entry ". ( 517)

Note!
In the Lenze setting, the profiles are assigned to certain operating modes, i.e. the
selection of a profile also results in a change of operating mode:
• If profile 0 is stipulated: Activation of "Speed follower" operating mode
• If profile 1 is stipulated: Activation of "Homing" operating mode
• If profile 2 is stipulated: Activation of "Manual jog" operating mode
• If profile 3 ... 15 is stipulated: Activation of "Positioning" operating mode
In the control modes " Terminals 0 " (Lenze setting) and " Terminal 16 ", changeover
between profile 1 (homing) and profile 3 (positioning) can be effected via the digital
input DI5.
In the control modes "
Terminals 2 " and " Terminals 11 " profiles 0 ... 3 can be selected via
the digital inputs DI4 and DI5.