Lenze 8400 - Manual (Page 45)

Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
45
2 Introduction: Parameterising the controller
2.4 Device access protection
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Activating device personalisation
The device personalisation is activated by setting a binding ID.

How to set a binding ID:
1. Enter the desired binding ID in C00505/2 .
• The binding ID must have a length of 4 ... 16 characters.
• The binding ID may consist of any character. However, this is not sensible.
Recommended characters are: lower case letters (a - z), upper case letters (A - Z) and
digits (0 - 9).
2. Execute "Set binding ID" device command C00002/29 = "1: On / start"
• After successful execution, status ON is displayed in C00505/2 .
C00002/29 Set binding ID
 Activating device personalisation
0: Off / ready
C00002/30 Delete binding ID
 Deactivating the device personalisation/changing the binding ID
0: Off / ready
Status displays
C00003 Status of the last device command -
C00507/1 Password protection - all communication channels
• Bit coded display of the active protective functions:
-
Bit 0 Only access to user menu
Bit 1 Parameter write protection
Bit 2 Parameter read protection
Bit 3 ... 14 Reserved
Bit 16 Memory module binding on
Parameter Info Lenze setting
Highlighted in grey = display parameter