Metrohm tiamo 2.3 Patch 1 (process analysis) User Manual
Page 1025
■■■■■■■■■■■■■■■■■■■■■■
5 Method
tiamo 2.3 Patch 1 (for Process Analysis)
■■■■■■■■
1009
If the option not defined is selected as Device name, any device types
or device groups which are able to execute the command can be selected,
independently of the devices in the device table.
Selection
Device types | Titrando
Default value
Titrando
Sensor
Measuring input
Selection of the measuring input the sensor is connected to.
Titrando
Selection
1 | 2
Default value
1
855, 867
Selection
1
Default value
1
Sensor
Selection of an ISE sensor from the ISE sensors available in the sensor
table.
Selection
'Sensor name' | ISE electrode
Default value
ISE electrode
Temperature measurement
Type of temperature measurement.
Titrando, 855
Selection
continuous | automatic | off
Default value
automatic
continuous
A temperature sensor must be connected. The temperature will then
be measured continuously.
automatic
If a temperature sensor is connected then the temperature will be
measured continuously. Otherwise the temperature entered manually
under Temperature on the Titration parameters tab will used.
off
The temperature will not be measured. The temperature entered man-
ually under Temperature on the Titration parameters tab will be
used.