Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1554)

7.10 778/789 Sample Processor ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1538 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
7.10 778/789 Sample Processor
7.10.1 778/789 Sample Processor - Overview
Dialog window: Configuration ▶ Devices ▶ [Edit] ▶ Properties… ▶ Properties - 'De-
vice type' - 'Device name'
The parameters for the devices 778 Sample Processor and 789
Robotic Sample Processor XL are set on the following tabs:
￭ General
General device information such as device name, device type, serial
number, etc.
￭ Tower #
Properties of Tower 1 and Tower 2 (if present). These tabs are only dis-
played if the Sample Processor is connected to the PC via an RS-232
interface.
￭ Rack
Information on the rack attached. This tab is only displayed if the Sam-
ple Processor is connected to the PC via an RS-232 interface.
￭ MSB #
Properties of the MSB connector 1...3 and the peripheral devices con-
nected to. These tabs are only displayed if the Sample Processor is con-
nected to the PC via an RS-232 interface.
￭ RS-232
Selection of the serial interface the device is connected to.
￭ GLP
Information on GLP tests and GLP monitoring.
7.10.2 Properties - General
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ General
On the tab General, general properties of the device are displayed.
Device name
Designation of the device (can be freely defined by user).
Input 50 characters
Default value Device type number_#
Device type
Display of the device type.
Program version
Shows the program version of the device.
Only visible with devices that have their own firmware.