Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1514)

7.2 Titrino ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1498 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
Time interval
on | off (Default value: off)
If this option is switched on then the request to prepare the dosing device
will appear after the time interval defined here.
all
Time interval after which the request to prepare the dosing device will
appear.
Range 0.1 ... 999.9 h
Default value 12 h
Connected devices
Here the device (685 or 700) connected to the dosing device connector is
displayed with its properties.
Dosing device type
Display of the dosing device type.
7.2.5 Properties - RS-232
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties ▶ Properties - 'Device type' -
'Device name' ▶ RS-232
COM Port
Selection of the serial interface on the PC to which the device is connec-
ted.
Selection COM1 | COM2 | … | COMn
Default value COMn
COMn
First free COM port.
Baud rate
Transmission speed. Additionally, this baud rate must be set on the device
itself.
Selection 1200 | 2400 | 4800 | 9600
Default value 9600
[Connect]
Establishes a connection to the RS-232 device.
[Disconnect]
Disconnects the connection to the RS-232 device.