Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1478)

6.10 Subwindow Global variables ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1462 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
They are either entered manually in the configuration or assigned in the
method run by a CALC command.
Note
For global variables which are newly calculated during a determination
in a CALC command and which are saved in the configuration, the cur-
rent values are available for additional calculations in the same determi-
nations from this instant. This is not the case for determinations running
at the same time on other workplaces; here, the values available at the
start of the determination are applied.
6.10.2 Table of global variables
6.10.2.1 Table of global variables
Subwindow: Configuration ▶ Global variables
Contents
The table of global variables shows the following information about the
global variables as standard:
Name
Name of global variable.
Type
Type of global variable (Number, Text or Date/Time).
Value
Value of the global variable.
Unit
Unit of global variable.
Assignment date
Date of the last value assignment to global variable.
Assignment method
Name of the method used to assign the value.
User
Short name of the user logged in during value assignment.
Client ID
Identification of the client (client ID) on which the value assignment has
taken place.