Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1668)

7.21 Stepping motor controller ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1652 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
Port
Display of the internal designation for a stepping motor of the type Dig-
Out_x_y_z, whereas x stands for the controller; y for the digital output
terminal and z for the output on this terminal.
Port description
Freely selectable designation for a stepping motor port. This designation is
used in the program to actuate the port.
Input 50 characters
Default value DigOut_x_y_z
The following characters must not be part of the
port description: \ , ', ., {, }, [, ].
Type
Selection of the port type.
Selection Linear drive | Rotary drive
Default value Linear drive
Default values for commands
Action
Action that the stepping motor is to carry out.
Selection 'empty' | Reference position | Relative position
| Absolute position | End position | Reset
Default value 'empty'
Reference position
Move to the reference position of the stepping motor.
Relative position
Move to a relative position, whereby the stepping motor moves relative
to the current position by the value defined under Distance/Angle.
Absolute position
Move to an absolute position, whereby the stepping motor moves to
the value defined under Distance/Angle.
End position
Move to the end position of the stepping motor.
Reset
A reset is carried out on the terminal the motor is connected to. While
doing so, the LEDs of the terminal will shortly flash, afterwards it could
be necessary to reference anew.
Distance
Distance to be moved to.