Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1372)

6.3 Configuration data ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1356 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
1 = Line active and
* = Any line status.
Selection Bit pattern with 8 characters (0, 1, *) | ********
Default value ********
The input lines and bits are numbered from right to left:
Input 7 6 5 4 3 2 1 0
Bit 7 6 5 4 3 2 1 0
Example: *******1 expects an active input line 0 (1 = set). For example,
this line is set by a Titrino after a titration has been completed and the
Titrino can accept a start signal again.
Note
Input lines that are of no interest or for which no defined condition can
be predicted should also be masked with an asterisk *.
6.3.3.3 Templates - Output lines
6.3.3.3.1 Managing templates for output lines
Dialog window: Configuration ▶ Tools ▶ Templates ▶ Output lines... ▶ Templates
for output lines
The client-specific bit pattern for setting remote output signals can be
defined in the dialog window Templates for output lines; these can be
selected with the command CTRL and in Manual Control. The table with
the defined templates cannot be edited, although it can be sorted accord-
ing to the selected column in increasing or decreasing sequence by click-
ing on the column title
[New]
Create a new template (see Chapter 6.3.3.3.2, page 1356).
[Edit]
Edit the selected template (see Chapter 6.3.3.3.2, page 1356).
[Delete]
Delete the selected template.
6.3.3.3.2 Editing templates for output lines
Dialog window: Configuration ▶ Tools ▶ Templates ▶ Output lines ▶ Templates
for output lines ▶ [New] / [Edit] ▶ New template / Edit template
With [New] or [Edit] the dialog window New template or Edit tem-
plate opens for entering a new template or for editing an existing tem-
plate.