Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1610)

7.17 RS-232 device ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1594 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
Sending characters separately
on | off (Default value: off)
If this option is enabled each character is sent separately. The delay time is
allowed to run before sending the next character.
Delay time
Delay time until the sending of the next character.
Range
0 ... 9999 ms
Default value 0 ms
[Connect]
Establishes the connection to the RS-232 device. The dialog window
Establish connection appears (see Chapter 7.17.5, page 1596).
[Disconnect]
Disconnects the connection to the RS-232 device (only then the device
can be deleted out of the configuration).
7.17.4 Properties - GLP
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ GLP
GLP test date
Date of the last GLP test. This date can be selected by clicking on in
the dialog window Select date (see Chapter 2.5.1, page 92).
Comment on GLP test
Comment on GLP test.
Input 1000 characters
Monitoring of GLP validity
Monitoring of GLP validity
on | off (Default value: off)
If this option is enabled then the time interval for the GLP test will be
monitored.
Monitoring can only be switched on when a date has been entered in
the field GLP test date.
GLP test interval
Time interval to next GLP test. If a value is entered here then the date in
the field Next GLP test will be adjusted automatically.