Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1638)

7.20 IO controller ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1622 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
[Edit]
Opens the dialog Properties - 'Controller type' in order to edit the
selected controller (see Chapter 7.20.8.1, page 1622).
[Delete]
Deletes the selected controller.
7.20.8.1 Properties - Controller type
Controller name
Freely selectable designation for the controller. This designation is used in
the program to actuate the controller.
Input 1 ... 50 characters
Default value Controller 1
The following characters must not be part of the
controller description: \ , ', ., {, }, [, ].
Controller behavior with
Action at power on
Action which is to be executed when the device is switched on.
Selection Stop control | Continue
Default value Stop control
Action with emergency stop
The action which is to be performed with an emergency stop.
Selection Stop control | Ignore emergency stop | Con-
tinue control
Default value Stop control
Action with end of control
The action which is to be performed with the end of the control or when
there is an error.
Selection Retain values for outputs | Set standard val-
ues for outputs
Default value Retain values for outputs
[Details]
Opens the dialog Details - 'Controller type' in order to edit the selected
controller.