Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1026)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1010 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
Stirrer
Stirrer
Selection of the stirrer.
Selection 1 | 2 | 3 | 4 | off
Default value 1
off
Means that no stirrer will be used.
Stirring rate
Setting the stirring rate. The algebraic sign of the stirring rate changes the
direction in which the stirring is done.
Range -15 ... 15
Default value 8
Switch off automatically
on | off (Default value: off)
If this option is activated, the stirrer will be switched off automatically
when the command has finished.
5.6.4.9.3 MEAS Conc - Measuring parameters
Tab: Method ▶ MEAS Conc ▶ Properties... ▶ Measuring parameters
Command name
Name of the command.
Input 25 characters
The parameters for the measuring procedure can be defined on this tab.
Measurement
The two measuring modes Measurement with drift control or Meas-
urement without drift control can be selected.
Selection Measurement with drift control | Measure-
ment without drift control
Default value Measurement with drift control
Measurement with drift control
The measurement is carried out drift-controlled if this option is ena-
bled. The measurement is stopped as soon as the defined Signal drift
or the Stop measured value is reached or a waiting time has
elapsed. The corresponding parameters are not visible if this option is
disabled.