NETGEAR MS510TXPP 8 Port Gigabit PoE Managed Switch - Manual (Page 174)

Smart Managed Pro Switches MS510TX and MS510TXPP
Configure Routing User Manual 174
The value is also included in router advertisements. The valid values for hops are 1 to
255, inclusive. The default is 64.
8. In the ICMPv6 Rate Limit Error Interval field, specify the number of ICMP error packets
allowed per burst interval.
This value controls the ICMPv6 error packets. The default rate limit is 100 packets per
second, meaning that the burst interval is 1000 mseconds. To disable ICMP rate limiting,
set this field to 0. The valid rate interval must be in the range 0 to 2147483647 mseconds.
9. In the ICMPv6 Rate Limit Burst Size field, specify the number of ICMP error packets
allowed per burst interval.
This value controls the ICMP error packets. The default burst size is 100 packets. When
the burst interval is 0, then configuring this field is not a valid operation. The valid burst
size is 1 to 200.
10. In the IPv6 MTU field, enter the maximum transmission unit (MTU) for IPv6 packets.
The MTU for IPv6 packets can range from 1280 to 9000. The default is 1500.
11. Click the Apply button.
Your settings are saved.
Add a Static IPv6 Route
To add a static IPv6 route:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the Switch on page 14 .
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password .
The System Information page displays.
5. Select Routing  > IPv6 > Basic > Route Table .