Send an ipv4 traceroute – NETGEAR MS510TXPP 8 Port Gigabit PoE Managed Switch User Manual
Page 329
Smart Managed Pro Switches MS510TX and MS510TXPP
Maintain the Switch and Perform
Troubleshooting
User Manual
329
Send an IPv4 Traceroute
Use this page to tell the switch to send a traceroute request to a specified IP address or host
name. You can use this to discover the paths that packets take to a remote destination. Once
you click the
Apply
button, the switch sends a traceroute and the results are displayed below
the configurable data.
To send an IPv4 traceroute:
1.
Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2.
Launch a web browser.
3.
In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
The login window opens.
4.
Enter the switch’s password in the
Password
field.
The default password is
password
.
The System Information page displays.
5.
Select
Maintenance > Troubleshooting > Traceroute IPv4
.
The Traceroute page displays.
6.
In the
IP Address/Hostname
field, enter the IP address or host name of the device for
which the path must be discovered.
The maximum number of characters in a name is 160.
7.
In the
Probes Per Hop
field, enter the number of probes per hop.
The range is 1 to 10. The default value is 3.
8.
In the
MaxTTL
field, enter the maximum time to live (TTL) for the destination.
The range is 1 to 255. The default value is 30.
9.
In the
InitTTL
field, enter the initial TTL to be used.
The range is 1 to 255. The default value is 1.
10.
In the
MaxFail
field, enter the maximum number of failures allowed in the session.
The range is 0 to 255. The default value is 5.
11.
In the
Interval (secs)
field, enter the time between probes in seconds.
The range is 1 to 60. The default value is 3.
12.
In the
Port
field, enter the UDP destination port for the probe packets.
The range is 1 to 65535. The default value is 33434.