NETGEAR MS510TXPP 8 Port Gigabit PoE Managed Switch User Manual
Page 263
Smart Managed Pro Switches MS510TX and MS510TXPP
Manage Device Security
User Manual
263
For information about the possible match criteria fields, see the following table.
ACL Based On
Fields
• Destination MAC
. Specify the destination MAC address to compare against
an Ethernet frame. The valid format is xx:xx:xx:xx:xx:xx. The BPDU keyword
might be specified using a destination MAC address of 01:80:C2:xx:xx:xx.
• Destination MAC Mask
. Specify the destination MAC address mask, which
represents the bits in the destination MAC address to compare against an
Ethernet frame. The valid format is xx:xx:xx:xx:xx:xx. The BPDU keyword
might be specified using a destination MAC mask of 00:00:00:ff:ff:ff.
• Source MAC
. Specify the source MAC address to compare against an
Ethernet frame. The valid format is xx:xx:xx:xx:xx:xx.
• Source MAC Mask
. Specify the source MAC address mask, which
represents the bits in the source MAC address to compare against an
Ethernet frame. The valid format is (xx:xx:xx:xx:xx:xx).
• Destination IP Address
. Specify the destination IP address.
• Destination IP Mask
. Specify the destination IP address mask.
• Source IP Address
. Specify the source IP address.
• Source IP Mask
. Specify the source IP address mask.
• Destination Prefix
. Specify the destination prefix.
• Destination Prefix Length
. Specify the destination prefix length.
• Source Prefix
. Specify the source destination prefix.
• Source Prefix Length
. Specify the source prefix length.
• Destination L4 port (protocol)
. Specify the destination IPv4 L4 port
protocol.
• Destination L4 port (value)
. Specify the destination IPv4 L4 port value.
• Source L4 port (protocol)
. Specify the source IPv4 L4 port protocol.
• Source L4 port (value)
. Specify the source IPv4 L4 port value.
• Destination L4 port (protocol)
. Specify the destination IPv6 L4 port
protocol.
• Destination L4 port (value)
. Specify the destination IPv6 L4 port value.
• Source L4 port (protocol)
. Specify the source IPv6 L4 port protocol.
• Source L4 port (value)
. Specify the source IPv6 L4 port value.
11.
In the Binding Configuration section, from the
Direction
menu, select the packet filtering
direction for the ACL.
Only the inbound direction is valid.
12.
In the Ports and LAG tables in the Binding Configuration section, click each port and LAG to
which the ACL must be applied.
Selected ports and LAGs are marked with a check mark.
13.
Click the
Add
button.
The rule is added to the ACL.
Destination MAC
Source MAC
Destination IPv4
Source IPv4
Destination IPv6
Source IPv6
Destination IPv4 L4 Port
Source IPv4 L4 Port
Destination IPv6 L4 Port
Source IPv6 L4 Port