NETGEAR MS510TXPP 8 Port Gigabit PoE Managed Switch - Manual (Page 344)

Smart Managed Pro Switches MS510TX and MS510TXPP
Configuration Examples User Manual 344
controls the authorized/unauthorized state of the controlled port depending on the outcome of
the RADIUS-based authentication process.
Supplicant
Authenticator switch
Supplicant
Radius
authentication
server
(192.100.10.23)
Figure 1. 802.1X authentication roles
802.1X Example Configuration
This example shows how to configure the switch so that 802.1X-based authentication is
required on the ports in a corporate conference room (mg7–mg8). These ports are available
to visitors and must be authenticated before access is granted to the network. The
authentication is handled by an external RADIUS server. When the visitor is successfully
authenticated, traffic is automatically assigned to the guest VLAN. This example assumes
that a VLAN was configured with a VLAN ID of 150 and VLAN name of Guest.
1. On the Port Authentication page, select ports mg6 through mg8 .
2. From the Port Control menu, select Auto .
The selection from the Port Control menu for all other ports on which authentication is
not needed must be Authorized . When the selection from the Port Control menu is
Authorized , the port is unconditionally put in a force-authorized state and does not
require any authentication. When the selection from the Port Control menu is Auto , the
authenticator PAE sets the controlled port mode.
3. In the Guest VLAN field for ports mg7–mg8, enter 150 to assign these ports to the guest
VLAN.
You can configure additional settings to control access to the network through the ports.
See
Configure a Port Security Interface on page 251 for information about the settings.
4. Click the Apply button.