NETGEAR MS510TXPP 8 Port Gigabit PoE Managed Switch - Manual (Page 59)

Smart Managed Pro Switches MS510TX and MS510TXPP
Configure System Information User Manual 59
Configure SNMP
You can configure SNMP settings for SNMPv1/v2 and SNMPv3. The switch supports the
configuration of SNMP groups and users that can manage traps that the SNMP agent
generates.
The switch uses both standard public MIBs for standard functionality and private MIBs that
support additional switch functionality. All private MIBs begin with a hyphen (-) prefix. The
main object for interface configuration is in -SWITCHING-MIB, which is a private MIB. Some
interface configurations also involve objects in the public MIB, IF-MIB.
Output Power (W) The power that is delivered to the PD in watts.
Status The operational status of the port. The possible values are as follows:
• Disabled . No power is delivered.
• Delivering Power . Power is being drawn by the PD.
• Requesting Power . The port is requesting power.
• Fault . A problem occurred with the power.
• Test . The port is in test mode.
• Other Fault . The port is idle because of an error condition.
• Searching . The port is not in one of the other states in this list.
Fault Status The description when the PoE port is in a fault or non-errors state. The possible
values are as follows:
• Port is off. Detection is in process. The port is not delivering power but can
detect whether a PD is being attached to the port.
• No Error . The port is not in any error state and provides power.
The fault status can also be any of the following:
• Main supply high voltage .
• Main supply low voltage .
• Hardware pin disabled .
• Non 802-3af powered device .
• Overload .
• Underload .
• Overload and underload .
• Budget exceeded .
• Voltage injection .
• Improper capacitor detection .
• Discharged load .
• Forced power – overload .
• Short .
• Port overheat .
• Device overheat .
• Class error .
Field Description