Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 227)

L-force | PLC Designer
Menu Commands sorted by Categories

DMS 4.1 EN 03/2011 TD29 225
• Notice also the Breakpoints command which is available in the 'View' menu for
opening the breakpoints dialog.
12.3.2 Toggle Breakpoint
Default Shortcut: <F9>
This command (category Breakpoints) basically toggles between status 'enabled' ( )
and 'disabled' ( ) of a breakpoint. However it also effects that a new breakpoint will be
set if not yet one is already set at the current breakpoint position. (For defining a new
breakpoint regard also the possibility of using the New Breakpoint dialog.)
Notice that an enabled breakpoint after logout and re-login automatically will be
disabled.
Note: Each active breakpoint will get an "inactive" one, when you leave online mode
and login again afterwards.
An active breakpoint is indicated by the symbol, an inactive one by the symbol.
Note: See also the corresponding functions in the 'Breakpoints' dialog.
12.3.3 New Breakpoint...
Symbol:
This command (category Breakpoints) is used to insert a new breakpoint in one of the
project's POUs. It does not care where the cursor currently is placed, the 'New
Breakpoint' dialog will open where in sub-dialog Location you can choose one of the
possible breakpoint positions allover the project and in sub-dialog Condition can
define some conditions for the new breakpoint.
Note: For setting a breakpoint at the current cursor position notice command Toggle
Breakpoint. See also the corresponding functions in the 'Breakpoints' dialog.