Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 533)

L-force | PLC Designer
Menu Commands sorted by Categories

DMS 4.1 EN 03/2011 TD29 531
12.35 Views
Windows of the "view" type can be handled by the commands which belong to
command category "view". Notice additionally the special command category
'Message View'.
12.35.1 Cross Reference View
View commands - Cross Reference View
The 'Cross Reference View' plug-in provides the command Crossreference View
(command category 'View' ) which is used to open the view for the references of a
variable within the project.
By default this command is part of the 'View' menu. If necessary open the Customize
dialog to view resp. modify the menu configuration (notice category 'View').
Cross Reference View
This command (category View) opens a view window where you can get listed the
cross references of a project variable, that is the locations where the variable is used
within the project or just within the scope of the same POU. The view is titled Cross
Reference List.
Abb. 282 Cross Reference List view, example