Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 242)

L-force | PLC Designer
Menu Commands sorted by Categories
240 DMS 4.1 EN 03/2011 TD29

Abb. 74 Edit Working Sheet dialog
Working sheet dimensions:
Use the following dimensions: If this option is activated, the size of the worksheet will
be determined by the following width and height values:
Width: Shows the current width in grid units. Can be edited, whereby it will not be
possible to enter a width smaller than that which is actually required by the existing
elements. Increasing the value (X) will enlarge the width horizontally to the right.
Height: Shows the current height in grid units. Can be edited, whereby it will not be
possible to enter a height smaller than that which is actually required by the existing
elements. Enlarging the value (Y) will enlarge the working sheet vertically downwards.
Adapt the dimensions automatically.: This option is activated by default. The size of
the working sheet is defined by the bottommost (height) and the rightmost (width)
element borders within the editor window. The origin (X=0, Y=0) is in the upper left
corner.
Move the working sheet origin relatively.: If this option is activated, the working sheet
can be shifted vertically and/or horizontally by the offset values given in the following.
The restrictions: The shift might not lead to an upper left corner less than 0/0. If option
'Use the following dimensions' is activated in the upper part of the dialog, the shift
may not exceed the width and height defined there. If option 'Adapt the dimensions
automatically' is activated, the shift might exceed the current dimensions and the
width and height values will be updated accordingly.
X offset: By default is 0. Entering a positive value shifts the chart to the right, thus
possibly increasing the width of the working sheet. Entering a negative value shifts the
chart to the left, thus only possible, if there is space between the leftmost element and
the left window border.