Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 810)

L-force | PLC Designer
General Editors
808 DMS 4.1 EN 03/2011 TD29

End of area Value limiting area range from above M,BD
Color Color the area shall be displayed in M,BD
Normalstate
Framecolor Static definition: color of the element
frame in basic state R,rR,E,P,pL,C Te
Fillcolor Static definition: fill color of the
element in basic state; R,rR,E,P,pL,C Te
Alarmstate
Framecolor Static definition: color of the element
frame in alarm state R,rR,E,P,pL,C Te
Fillcolor Static definition: fill color of the
element in alarm state R,rR,E,P,pL,C Te
Elementlook (Linewidth, Linestyle, FromTopLeft (declination), Fillattributes,
Frameattributes, m_ShadowType)
These are static definitions concerning the looking of the outline and of the filling of
the element.
For dynamic definition see category 'Look variables'.
Linewidth Width of the outline in pixels; "0" equals "1" R,rR,E,P,L,pL,C,F,Im Te
Linestyle Type of the line:
PS_SOLID ____
PS_DASH _ _ _
PS_DOT . . .
PS_DASHDOT _ . _ .
PS_DASHDOTDOT _ . . _ . .
PS_HOLLOW (not visible) L
FromTopLeft If this option is activated, the line declines from
top left to bottom right, otherwise it rises from
bottom left to top right. L
Fillattributes Look of the outline:
BS_SOLID: the line is visible
BS_HOLLOW: the line is not visible R,rR,E,P,pL,C Te
Frameattributes Type of the outline:
PS_SOLID ____
PS_DASH _ _ _
PS_DOT . . .
PS_DASHDOT _ . _ .
PS_DASHDOTDOT _ . . _ . .
PS_HOLLOW (not visible) R,rR,E,P,pL,C,F,Im Te
m_ShadowType Type of the shading of the outline:
DEEPEND
NONE
RAISED Te