Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 839)

L-force | PLC Designer
General Editors

DMS 4.1 EN 03/2011 TD29 837
Now, if you for example try to compile or save the project, first the dialog for the
configuration of the new parameters will appear:
Abb. 456 Dialog for Updating the frame parameters
For all visualizations referencing the modified basic_visu, thus visu2 and visu3, each
the current and the previous values of the interface parameters are displayed. The
current value can be (re-)configured here. The shading of the value-fields in the table
indicates where still entries are required resp. have been done already (see also the
legend in the bottom of the dialog):
beige shading: This parameter automatically has been copied from the previous
configuration (for example PLC_PRG.iVar for visu2).
grey shading: Not yet any value has been assigned to this new parameter (for example
strText for visu2 and visu3).