Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 327)

L-force | PLC Designer
Menu Commands sorted by Categories

DMS 4.1 EN 03/2011 TD29 325
Remember this mapping for all future occurrences of that device.: If this option is
activated, the settings of the dialog, that is the currently defined conversion mapping
for the device, will be stored in the »PLC Designer« 2.3 Converter options and thus be
applied at further conversions.
Note: For the »PLC Designer« V2.3 converter: Adapting a V2 project with respect to
the V3 syntax on import can only be done if the project can be compiled in the
converter without detected errors.
Note: For the »PLC Designer« V2.3 converter: The project directory defined in the
V2.3 project options as well as the project information will be applied to the Project
Information dialog.
4) If the Auto Save function had been activated and »PLC Designer« had been
terminated non-regularly before the last project was saved after a modification, you
will get the 'Auto Save Backup' dialog when going to re-open the same project. For
details see Options for Load and Save.
5) If the project you want to open is read-only on disk, you will be asked whether you
want to open the project in read-only mode or whether you want to make the project
writable.
6) If you try to open a library project installed in a Library Repository you will get an
error message. The library project cannot be opened from the given path.
After closing the dialog with OK, the project name will appear in the title bar of the
user interface frame. An asterisk behind the project name in the title bar indicates that
the project has been modified since the last save.
Close Project
Batch command: file close (not yet implemented)
This command (category 'File') will close the project while the programming system
will stay opened. If the project contains non-saved modifications, you will be asked
whether you want to save these changes.
Abb. 134 Dialog asking whether to save a changed project:
For terminating »PLC Designer« use command Exit.