Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 929)

L-force | PLC Designer
Device Editors

DMS 4.1 EN 03/2011 TD29 927
Profibus DP I/O Mapping Master
This dialog serves to map the inputs and outputs of a Profibus device to project
variables. The handling corresponds to that of the mapping dialog provided by the
Device editor also for other device modules.
NetX configuration
In case of a NetX fieldbus this dialog is available as one of the tabs in the device editor
of the master, for selecting the NetX chip (slot for the card) and the communication
channel of this chip. The name of the setting used in the dialog and the possible
settings provided by the selection lists are defined by the device description.
Abb. 510 NetX configuration dialog, example
Slot: Slot to be used. In case of PCI cards with NetX chip the slot numbers usually
correspond to the PCI card numbers.
NetX Com Channel: Channel on the card to be used for the communication. A NetX
board may have up to four communication channels for different fieldbusses.
Regard in case of a Profibus NetX configuration the possibility to check the hardware
for the currently available bus participants by calling method GetLiveList (provided by
the automatically included IoDrvCifXProfibus.library). On a rising edge at input xEnable
the method requests a current list of all participants connected to the Profibus. The
operation has been terminated when output wOpState is HIL_DONE or HIL_ERROR.
The method can return the following values: 00 = station not available, 01 = inactive
station, 03 = active station.
Status
This dialog is provided on a tab of the Device dialog (Device Editor). It shows status
information (for example "Running", "Stopped") and device-specific diagnostic
messages, also on the used card and the internal bus system.
Information
This dialog is generically provided on a tab of the device editor dialog and shows some
general information on the device.