Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 528)

L-force | PLC Designer
Menu Commands sorted by Categories
526 DMS 4.1 EN 03/2011 TD29

12.34.6 Ungroup
Symbol:
This command (category Visual Commands) resolves a selected group of elements. The
particular elements will be displayed each selected. See also: Group.
12.34.7 Frame selection
This command (category Visual Commands) is used to configure the content of a
Frame element.
A Frame element is used to define a subarea of a visualization which includes one or
several other visualizations. In online mode it can be toggled between the display of
these particular visualizations.
Basically the first visualization in the list of visualizations assigned to the frame will be
displayed. But by an input on another - appropriately configured (Input properties,
Switch Framevisualization) - visualization element the user might effect that one of
the other assigned visualizations will be displayed in the frame. Thus switching
between different displays within a visualization is possible, in contrast to »PLC
Designer« V2.3, where one always had to jump completely between the particular
visualizations.
The visualizations included in a frame are references, that is instances of the original
visualizations, and placeholders defined in the original visualization objects can be
replaced by locally applicable values. See in this context the following page:
Frames,_References,_Interface (Placeholder)
The selection of the visualizations in a frame is done in the Frame Configuration
dialog, which is opened by the 'Frame selection' command:
Abb. 280 Frame Configuration dialog