Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 384)

L-force | PLC Designer
Menu Commands sorted by Categories
382 DMS 4.1 EN 03/2011 TD29

12.20 Message View
Notice the commands of category 'Message View' if you want to navigate between
messages displayed in the message window or between messages and the
implementation code.
12.20.1 Message View commands
The 'MessageView' plug-in provides for command category 'Message View' commands
(see below) which serve to navigate between messages in the Messages Window
(Messages view) resp. between messages and the concerned position in the project.
By default these commands are part of the 'Edit' menu. If necessary open the
Customize dialog to view resp. modify the menu configuration (notice category
'Message View').
• Go To Source Position
• Next Message
• Previous Message
12.20.2 Go To Source Position
If the cursor is placed in a line of the message window which indicates a detected error
or alert (warning), use this command to get to that position in the project (source
position), which has caused the message. The cursor will be placed there. If the
concerned object was not yet opened in a window, it will be opened.
To get to the next resp. previous message use Next Message resp. Previous Message.
12.20.3 Next Message
Shortcut: <F4>
Use this command in the message window to set the focus to the next message.
12.20.4 Previous Message
Shortcut: <Shift>+<F4>
Use this command in the message window to set the focus to the previous message.