Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 928)

L-force | PLC Designer
Device Editors
926 DMS 4.1 EN 03/2011 TD29

Profibus DP Configuration
This dialog is only available in the device editor for a Profibus Master resp. Slave device,
if option 'Show generic device configuration views' is activated. It corresponds to the
Configuration dialog provided by the Device editor also for other device modules.
Abb. 508 Profibus DP Configuration dialog
The device-specific master or slave parameters defined by the manufacturer in the
device description file (extra, not in GS?-file) will be listed in a table and might be
edited there if allowed by the description file. Non-editable parameters are displayed
grey-colored.
DP-Module Configuration
This dialog is only available in the device editor of a Profibus module, if option 'Show
generic device configuration views' is activated. It corresponds to the Configuration
dialog provided by the Device editor also for other device modules.
Abb. 509 DP-Module Configuration dialog
DP-Module I/O Mapping
This dialog serves to map the inputs and outputs of a Profibus device to project
variables. The handling corresponds to that of the mapping dialog provided by the
Device editor also for other device modules.