Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 546)

L-force | PLC Designer
Menu Commands sorted by Categories
544 DMS 4.1 EN 03/2011 TD29

Change Binding: This button opens the 'Change Source Control Binding' dialog, where
you can modify the data base location to which the object is bound:
Abb. 293 Properties dialog, Change Source Control Binding
Default binding: This option is by default activated. The object is bound to the data
base location which has been specified when setting the project under source control
in the Change Source Control dialog. The respective Host name, Port and data base
Location are shown.
Special binding: In order to bind the object to another than the default location (see
above, Default binding), activate this option and enter the appropriate Host name, Port
and Location. The
button might be used to get a dialog for browsing for the desired
location.
No binding: Activating this option means that the object is not stored in the data base.
It is just stored locally with the project (corresponding to object category "Local" used
in »PLC Designer«V2.3)
Build (Exclude from build, Enable system call, External implementation, Link Always,
Compiler defines)
Concerning the compilation (build) the following options can be activated:
Exclude from build: The object will not be noticed during the next 'Build' run.
External implementation (Late link in the runtime system): No code is created for this
object during a compilation of the project. The object will be linked when running the
project on a target, if it is available there, for example via a library.