Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 285)

L-force | PLC Designer
Menu Commands sorted by Categories

DMS 4.1 EN 03/2011 TD29 283
Serves to set the interface of the Main Net Executing this command will
open a dialog for selecting an appropriate driver, wherein all block drivers
configures so far are listed:
Abb. 106 Dialog - Select Driver Form
You may select an entry by an click and confirm your selection by OK or
abort the operation with Cancel.
The bottom part contains the characteristic settings of the selected entry. For a driver
these parameters correspond to the configuration done in tab block drivers. For a
router you may edit here its Name.