Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 290)

L-force | PLC Designer
Menu Commands sorted by Categories
288 DMS 4.1 EN 03/2011 TD29

12.12.7 Edit Gateway...
This command (category Device Communication) opens the Gateway dialog, which in
the Communication Settings is used for adding a gateway resp. for editing the settings
of the currently selected gateway.
12.12.8 Scan for Device by Name
Symbol:
This command (category "Device Communication") serves to scan the network for
devices of the same name as specified in the "Communication Settings" devices list
below the corresponding gateway entry (case sensitive search!). If any are found, each
of them will be added to the list with its specific node address, i.e. the entry will be
displayed with name + node address.
Example
USER1 [057B]
12.12.9 Scan for Device by Address
Symbol:
This Command (category "Device Communication") serves to scan the network for
devices with the same node address as specified in the "Communication Settings"
devices list below the corresponding gateway entry. If any are found, each of them will
be added to the list with its name, i. e. the entry will be displayed with name + node
address.
Example
USER1 [057B]
12.12.10 Scan Network
Symbol:
This command (category Device Communication) for which there is also a button in
the Communication Settings dialog, starts a search for available devices in your local
network and the configuration tree will be updated accordingly. The command will
also be executed on a doubleclick on the gateway entry.
The found devices will be listed below that gateway entry, in the tree of which an entry
has currently been selected when calling the command.