Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 419)

L-force | PLC Designer
Menu Commands sorted by Categories

DMS 4.1 EN 03/2011 TD29 417
12.22.25 Connect to <device>
This command (category Online) can be used to set up a connection to the device
which is currently selected in the device tree. As a precondition the communication
settings of the device must be configured properly.
12.22.26 Disconnect from Device
This command (category Online) can be used to disconnect from the device which is
currently connected and selected in the device tree.
12.22.27 Reset origin device
This command (category Online) is available in the context menu in offline and online
state, when a programmable device is selected in the device tree. It sets back the
device to the original ("shipping"`) state, as far as any application(s), boot project files
and remanent variables on the device will be deleted.
12.23 Preferences
The commands of category 'Preferences' are available for customizing the user
interface and set various »PLC Designer« and project options.
12.23.1 Preferences
Preferences commands - Frame
The 'Frame' plug-in provides for command category 'Preferences' commands (see
below) which serve to customize the user interface, to configure certain options for
user interface components which are provided via plug-ins also and to configure
directories which are necessary for the project.
By default these commands are part of the Tools menu, but regard that the Tools
menu itself also is configured in the Customize dialog (regard category 'Preferences').
The commands:
• Options
• Customize