Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 787)

L-force | PLC Designer
General Editors

DMS 4.1 EN 03/2011 TD29 785
The Trace Configuration dialog opens on command Configuration... which is available
in the context menu of the trace tree on the right part of the main Trace Editor
window. By double klick on the trace name or the variable names the dialog opens,
too. Here you configure which variables should be traced and which parameters
should be set for the tracing and the defined variables.
Note: The settings done in the dialog Record Settings are valid for all variables in the
trace graph.
The Trace Configuration is composed of one trace record configuration (Record
Settings) and of the dedicated variable settings. The configured trace variables are
visualized in the trace tree in the left part of the trace configuration dialog and is the
same than the one in the main trace editor window.
Abb. 429 Trace tree in the Trace Configuration dialog
See on top level the name of the configured trace and indented below the names of
the tracing variables. For changing the record settings select the name of the trace on
top level of the trace tree. Then the Record Settings dialog is opened.
For adding a variable to the trace or deleting one see the commands below the record
tree: New Variable, Delete Variable.