Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 292)

L-force | PLC Designer
Menu Commands sorted by Categories
290 DMS 4.1 EN 03/2011 TD29

If the cursor currently is placed within an existing network, the new network will be
inserted immediately above that network. If the cursor currently is placed in the editor
window but not in a network, the new network will be added at the end of the current
network list. The network numbering will be updated automatically.
Notice that in contrast to V2.3 the network element is also used in the IL editor.
Note: The display of the elements in a LD/FBD/IL network is defined in the 'FBD/LD
and IL editor Options'.
12.13.3 Insert Network below
Symbol:
Shortcut: <Ctrl> + <T>
This command (category 'FBD / LD / IL') is used to insert a network in the FBD, LD or IL
editor.
If the cursor currently is placed within an existing network, the new network will be
inserted immediately below that network. If the cursor currently is placed in the editor
window but not in a network, the new network will be added at the end of the current
network list. The network numbering will be updated automatically.
Notice that in contrast to V2.3 the network element is also used in the IL editor.
Note: The display of the elements in a LD/FBD/IL network is defined in the 'FBD/LD
and IL editor Options'.
12.13.4 Toggle network comment state
Symbol:
Shortcut: <Ctrl> + <O>
This command (category 'FBD / LD / IL') can be used in FBD, LD or IL editor to comment
out a network resp. to set it back from comment to normal state. The command will
effect the network in which the cursor is currently positioned.
A commented-out network will be displayed according to the options set for
comments and will not be noticed in program processing.
Abb. 110 Example: network, normal state and comment state
Note: Concerning the view options for the components of a LD / FBD network notice
the settings in the 'FBD/LD and IL editor Options'.