Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 305)

L-force | PLC Designer
Menu Commands sorted by Categories

DMS 4.1 EN 03/2011 TD29 303
12.13.23 Paste contacts: Paste above
Shortcut: <Ctrl> + <H>
This command (category 'FBD / LD / IL') is only available in LD editor. It pastes the
elements resp. the section of the network which has been put to the clipboard before
by a "copy" or "cut" command, above the currently selected contact element in the
network.
See Working in the FBD and LD editor view for a description on selecting in networks.
12.13.24 Insert IL line below
Symbol:
This command (category 'FBD / LD / IL') is only available in the Instruction List editor. It
is used to insert a further instruction line below the currently selected one.
12.13.25 Delete IL line
Symbol:
Shortcut: <Ctrl> + <Del>
This command (category 'FBD / LD / IL') is only available in the Instruction List editor. It
is used to delete the line where currently the cursor is positioned.
12.13.26 Negation
Symbol: (FBD), (LD)
Shortcut: <Ctrl> + <N>
This command (category 'FBD / LD / IL') is used in FBD or LD to toggle the negation of
an input, an output, a jump or a RETURN instruction. It is not available in the IL editor,
where the corresponding modifiers have to be used appropriately.
Attention: If view is switched from FBD or LD to IL view and back, the negations of
some constructs might be set back because an un-ambiguous conversion is not
possible.
At boxes, jumps or returns the symbol for the negation is a small circle at the
respective input or output connection.
A negated contact in LD is indicated by a slash in the contact symbol: