Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 779)

L-force | PLC Designer
General Editors

DMS 4.1 EN 03/2011 TD29 777
POUs:
The POUs which are currently controlled by the task are listed here in a table with POU
name and optionally a comment. Left to the table there are commands for editing:
• In order to define a new POU open the Input Assistant dialog via command Add
POU. There choose one of the programs available in the project.
• In order to replace a program call by another one, select the entry in the table, open
the Input Assistant via command Input Assistant and choose another program.
• In order to delete a call, select it in the table and use command Remove.
• Command Open POU opens the currently selected program in the corresponding
editor.
The sequence of the listed POU calls from up to down determines the sequence of
execution in online mode. Via the commands Move up and Move down the currently
selected entry can be shifted within the list.
NOT YET IMPLEMENTED: Manufacturer specific attributes:
Additionally to these standard attributes for the currently selected task manufacturer
specific attributes might be displayed in a second tab "Parameters". This will be the
case if it is defined in the target-specific description file for the task configuration.
Parameter dialog
This dialog is only available on a tab of the Task Editor dialog if defined by the target. It
provides manufacturer specific attributes of the task (Name, Type, Value, Description).
System Events dialog
NOT YET IMPLEMENTED