Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 661)

L-force | PLC Designer
General Editors

DMS 4.1 EN 03/2011 TD29 659
When using the Show generated code button a listing of the programmed motion of
the dedicated CNC object is shown. This can only be done, when the CNC program has
no errors. Then you can see the generated ST-code of the CNC program and there the
declaration part, who initializes the SMC_OutQueue respectively the SMC_CNC_REF.
13.3.7 CNC Online
In online mode the status line is invisible.
13.4 CNC Settings Editor
Symbol:
The CNC Settings object is generated automatically, when a CNC object is generated
and can't be renamed or removed. It is located in the device tree under a application.
Only one CNC setting object may exist there. The settings stored here are valid for all
CNC objects of the application. Settings only valid for a particular CNC program are
stored in the properties dialog of the CNC program.
A double-click on the CNC Settings object opens the CNC Settings dialog. There you can
define the settings for the path preprocessor, the preinterpolation and the CNC table
editor. The object can only be deleted, when no CNC object exists under the
application object.
Path Preprocessor
Abb. 351 CNC Settings for path preprocessor