Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 662)

L-force | PLC Designer
General Editors
660 DMS 4.1 EN 03/2011 TD29

Here the modulation program for the path preprocessor can be programmed by
selecting the desired function blocks. The position in the list of the active function
block instances defines the turn in the modulation program and can be changed. It is
possible to instantiate the same function block more than once in the active function
block instances list.
In the left part the available function blocks are listed, in the right part the active
function block instances. It is not possible to delete function block instances displayed
in italic light gray font.
Use this button or the Space key for copying a selected available function block
into the list of the active function block instances. The same can be done by double
clicking the desired function block in the left list .
Use this button or the Del key for deleting the selected instance.
Use this button for moving up the selected function block instance by one
position. The same can be done by using the Arrow Up key while pressing the Shift key.
Use this button for moving down the selected function block instance by one
position. The same can be done by using the Arrow Down key while pressing the Shift
key.
Some instances have parameters, which can be set and changed by clicking the button
Parameters or by double clicking on them in order to open the respective parameter
editor dialog. The same can be done by using Shift + P, Alt + P or P.
Preinterpolation
Abb. 352 CNC Settings for preinterpolation
Here the interpolation time can be set. Default value is 20000µs.
Note: Interpolation time and cycle time of the associated task have to match for
identical behaviour of CNC editor and online application.