Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 489)

L-force | PLC Designer
Menu Commands sorted by Categories

DMS 4.1 EN 03/2011 TD29 487
If you want to use an already existing location, you might use button to get the
Browse Location dialog which shows a folder tree of all currently available data base
locations. Select the desired location and confirm with OK to get it entered in the
'Location' field. When going to close the Change Source Control dialog with OK, you
will get the message that the chosen location is already in use and that the project
stored there might differ to the current one. At this time you can finally decide to use
the location anyway or to cancel.
If you want to use a new database location for the current project, just enter a name
for this location. When going to close the Change Source Control dialog with OK, you
will be asked whether you want to create this new location, that is create a new
database folder with the given name.
After having defined the existing or new location definitely, a dialog will appear asking
whether all objects of the project should be bound to this location.
If Yes, the objects will be indicated with database symbols in the POUs and Devices
view. The objects bound to the default location will be indicated by yellow symbols:
. If an object is already found in the database, you will be asked
whether it should be overwritten there.
If No, the objects will stay "unbound", that is will not be stored in the database. You
might add them resp. edit the binding status still later via the Object Properties dialog
or in the 'Advanced Settings' dialog as described in the following:
Advanced Settings: This button opens the 'Advanced Source Control Settings' dialog.
An overview on the bindings of all project objects is provided in a table view.
Abb. 259 Advanced Source Control Settings dialog