Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 23)

L-force | PLC Designer
About this documentation

DMS 4.1 EN 03/2011 TD29 21
1 About this documentation
This documentation contains information on the PLC programming with the »PLC
Designer« and makes the introduction to the powerful language constructs of IEC
61131 easier for you.
Target group
This documentation addresses to qualified personnel in accordance with IEC 364.
Information on the validity
The information in this documentation is valid for the following Lenze software:
Software From software version
L-force »PLC Designer« 3.0.0
Document history
Version Description
1.0 06/2008 TD29 First edition for the » PLC Designer«
2.0 08/2008 TD29 Revision
3.0 05/2009 TD29 Revision
4.0 10/2010 TD29 Update on software V3.4
5.0 03/2011 TD29 Update on software V3.5
Informations and utilities on Lenze products can be found in the "Downloads" area
under: http://www.Lenze.com
Liability
All information given in this documentation has been selected carefully and tested for
compliance with the hardware and software described. Nevertheless, discrepancies
cannot be completely ruled out. We do not accept any responsibility or liability for any
damage that may occur. Required corrections will be included in updates of this
documentation.
This documentation is based on the original »PLC Designer« documentation by the
company 3S - Smart Software Solutions GmbH (Kempten). The screenshots shown may
deviate from the »PLC Designer« representation.
Trademarks
Microsoft, Windows and Windows NT are either registered trademarks or trademarks
of Microsoft Corporation in the U.S.A. and/or other countries.
Adobe and Reader are either registered trademarks or trademarks of Adobe Systems
Incorporated in the U.S.A. and/or other countries.
All other product names contained in this online documentation are trademarks of the
corresponding owners.