Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 548)

L-force | PLC Designer
Menu Commands sorted by Categories
546 DMS 4.1 EN 03/2011 TD29

Network Properties (for Global Variables List)
If the network functionality is supported by the current device, then the Network
Properties of a GVL (Global Variable List) object can be viewed and edited in the
Properties dialog. Specifying network properties for a GVL means to make available the
included variables as network variables. A GVL is always to be defined by the "sender"
of the network variables. The receiver must have a corresponding GNVL list. Regard the
general description on how to use network variables.
Abb. 295 Properties dialog, Category Network Properties
Network type: Choose the desired type from the target-dependent selection list. For
example „CAN" as an abbreviation for a CAN network, or „UDP" for an UDP
transmission system might be selectable.
Task: From the selection list choose the task of the current application which should
control the sending of the variables. The variables always will be sent at the end of a
task cycle.
List identifier: Number (ID) of the first list to be sent (default = 1). Further lists will be
numbered in ascending order.