Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 264)

L-force | PLC Designer
Menu Commands sorted by Categories
262 DMS 4.1 EN 03/2011 TD29

12.9.3 Copy
Symbol:
Default Shortcut: <Ctrl>+<C>
This command (category 'Clipboard') copies the current selection from the editor to the
clipboard. This does not change the contents of the editor window.
In tree structures organizing objects as for example in the 'POUs' view, this applies to
the selected object. Multiple selections are possible.
Remember that not all editors support copying and that it can be limited with some
editors.
For the type of selection the same rules apply as with the Cut command.
In order to paste the content of the clipboard you use the Paste command.
In order to delete a selected area and simultaneously put it on the clipboard, use the
Cut command.
12.9.4 Paste
Symbol:
Default Shortcut: <Ctrl>+<V>
This command (category 'Clipboard') pastes the content of the clipboard onto the
current position in the editor window.
Pasting is not supported by all editors resp. its use might be limited. In graphic editors
the command is only supported if a correct structure will result from the insertion.
In tree structures which are used to organize objects, as for example in the POUs or
Devices view, the command applies to the selected object. Multiple selection is
possible. Depending on the current position, for example in the devices tree, a dialog
might be opened where you have to choose, whether the object from the clipboard
should be entered below or above.
In order to copy a selection onto the clipboard without deleting it, use the Copy
command.
In order to remove a selected area without changing the clipboard, use the Delete
command.